英语翻译SULFATREAT SELECT products will work in any water conten

英语翻译
SULFATREAT SELECT products will work in any water content range from dehydrated to water saturated gas.
Our SULFATREAT range,however,requires the gas to be water saturated.In some cases it may be necessary for a water injection system to be installed to ensure this condition is satisfied.
Just upstream of the SULFATREAT* vessel(s),the installation requires a small inlet separator to remove excess liquids from the gas.Care should be taken to insulate the lines and SULFATREAT vessel(s) to prevent a temperature drop of no more than 5° F after the last liquid separator across the outlet of the SULFATREAT vessel.
The actual design of the SULFATREAT vessel(s) can be customized to specific site needs based on inlet gas flow,operating pressure,desired pressure drop,and the days-to-outlet-H2S specification.Low predictable pressure drops,as low as a few inches of water,allow a wide range of reliable applications and equipment configurations.Properly constructed SULFATREAT vessels should last 20 years or more.
Equipment Arrangements - Single Vessel
The most basic design is a single vessel where the inlet H2S concentration is reduced at the outlet to “non-detect” at the beginning of the bed life,gradually increasing to an outlet specification.Temporary bypass of the vessel or interruption of gas flow is necessary for the short time it takes to replace the SULFATREAT* material.The main advantage of this type of system is that the capital costs are minimized.
Equipment Arrangements - Lead/Lag Vessels
There are two benefits of this vessel configuration.The first is that it allows for change outs of the spent media without interrupting the processing of the gas stream.In addition,there will be an improvement in the overall efficiency of the system that can be as high as 20%.This arrangement is feasible where the quantities of H2S increase and for systems operating with sufficient working pressure.
Two vessels are arranged in series,flowing gas through the first bed into the second.The lead vessel acts as the “working” unit to remove all of the H2S at the beginning of a treatment period,with its outlet H2S increasing over time.The gas can go to the second,or “lag” vessel for further polishing,or it can bypass the second vessel up to the desired gas H2S outlet specification.The operation of the lead bed is similar to the single-vessel arrangement.The second vessel can be placed in operation at startup,or it can be used to polish the H2S remaining in the gas from the lead vessel when the level of outlet H2S reaches the maximum specification.
不要直接在线翻译啊··翻出来的不准确··因为是做设计用··不能太离谱的··谢谢各位了

我是初一,所以我不会翻译,但是对于三楼,她不是自己翻译的,她是初一学生,我在她的一个回答看到的,对于这样的谎言,你是否该后悔呢?“我觉得是这样,可是好累啊!怎么这么多的啦!害我不可以用工具翻译,这下累死了!”哼,真可笑,初一学生有这么高水平吗?如果你不是初一,那么你在那个回答里也算是谎言咯!